6L Ultrasonic Cleaner With Intelligent Control, Frequency Sweeping And Degassing Functions – Laboratory And Medical Industry Equipment

1. Intelligent Degassing System
   Equipped with a built-in vacuum degassing pump and liquid level sensor, it can reduce the gas content in the cleaning solution to below 0.5% within 3 minutes (the gas content in conventional solutions is about 5%), achieving three core advantages:

• Enhanced Cavitation Effect: After degassing, the energy released by bubble collapse increases by 25%, and the cleaning efficiency at the same power level is improved by 30%. For example, the time required to remove sludge from 0.1mm - deep grooves in bearing raceways is shortened from 15 minutes to 10 minutes.
• Protection of Sensitive Materials: It prevents the formation of cavitation pits on the surfaces of easily oxidizable materials such as aluminum workpieces and silver ornaments. The removal rate of the oxidation layer on silver ornaments after degassing cleaning exceeds 99.5%, and no new scratches are generated.
• Stable Cleaning Performance: It eliminates the inconsistent cleaning caused by fluctuations in the gas content of the solution. The fluctuation of the yield rate between batches is controlled from ±8% to ±2%, meeting the strict consistency requirements of ISO 13485 for medical device cleaning.

2. Dynamic Frequency Sweeping Technology
   Through a broadband transducer array and an AI - based frequency tracking algorithm, it supports full - band scanning from 20 to 80kHz (with an accuracy of ±0.05kHz) and automatically matches the optimal cleaning frequency:

• Layered Cleaning of Multiple Contaminant Layers: For example, when cleaning PCB pads, it first breaks down solder balls at 25kHz and then switches to 75kHz to remove ionic residues of soldering flux, reducing the defect rate from 1.1% to 0.08%.
• Adaptive Load Adjustment: When the temperature of the cleaning solution changes (such as from 25°C to 60°C) or the liquid level fluctuates (±10%), the system completes frequency calibration within 0.3 seconds, avoiding the decay of cleaning efficiency caused by frequency drift in traditional equipment (the industry - average decay rate is 15%, while this product's is ≤3%).
• Penetration of Complex Structures: For precision parts with blind holes deeper than 5mm (such as MIM metal injection - molded parts), the frequency sweeping mode of 35 - 55kHz increases the penetration depth of ultrasonic energy by 40%. The cleanliness at the bottom of blind holes reaches the VDA 19.1 standard (the residual amount of particles > 5μm is < 5 particles/100cm²).